Share
Pin
Tweet
Send
Share
Send
Do you like working with wood? Then it is especially for you! Today I will show you how to assemble an old car model from plywood. So, let's begin. First you need to saw the following workpieces with a jigsaw: This is the foundation of the whole car. The left side is the front. | |
Here we add a roof so that you are roughly oriented with the proportions. | |
This is the left and right side of the car. | |
These are the wings. They also need two pieces. | |
Four wheels with stoppers. | |
Lateral surfaces of a motor compartment. | |
The back of the car. The so-called back. Performed in a single instance. | |
This, I do not know what to call. It is installed right behind the radiator lining. In general, you will see |
This is the panel between the passenger compartment and the engine compartment. All slots need to be done very carefully! | |
This is the engine compartment cover - the hood. It is necessary to carefully bend the plate, as shown in the photo. | |
And this is two headlights and a steering wheel. The steering wheel is a bit more headlights. | |
These are the outer decorative wings. Without them, the model will look unfinished. | |
This is the grille lining. To give a better look - you can apply a picture. | |
This is a set of seats, in order: the upper part of the front, the lower part of the front seat, and the rear seat. | |
Headlamps located on the partition between the passenger compartment and the engine compartment. | |
These are the two parts necessary to give a good look to the interior. |
Getting to the assembly of the car. We take the base, and fasten the sides on it. After assembly, we should get the following | |
Install the rear seat in the grooves in the sides. | |
This part is necessary for us for fastening the front seats. | |
Fasten the front seats. We fix the even part horizontally, and the part with the bulge, vertically. | |
Next, fasten the steering wheel, and put on the "steering ring" | |
Next, insert the back wall into a special groove | |
We insert the "dashboard" into its rightful place. | |
Now we put on the roof. It is necessary to get into special holes. |
Next, we install a partition between the passenger compartment and the engine compartment. | |
Next, install the side covers of the engine compartment. | |
Next, add the sandwich. And put it in the right place | |
Next, install the hood. | |
Next, we catch the lights, and the dimensions of the partition | |
After that we put on the wheels and fix them. For fixing it is necessary to turn the plugs as shown in the photo. | |
Then we fasten the outer wings. The car is assembled! | |
Share
Pin
Tweet
Send
Share
Send