TDA2030A Chip Sound Amplifier

Pin
Send
Share
Send

I found an unnecessary board from the TV. My eye was attracted by the TDA203A chip. I know that TDA microcircuits are low frequency amplifiers, there is a lot of information about them on the Internet. I decided to assemble my own simple amplifier according to the scheme:

It will be required for assembly


  • Chip TDA2030A.
  • Capacitors 0.1 microfarads - 3 pieces.
  • Capacitors 2200 μF 25 V - 2 pieces.
  • 2.2 ohm resistor.
  • Resistors 22 kOhm - 2 pieces.
  • 680ohm resistor.
  • Capacitor 22 uF 25 V.
  • 4.7 microfarad capacitor film.
  • Case, switch, wires, radiator, connectors for tulips.

Build a simple amplifier on the TDA2030


My goal was to create an amplifier without spending a lot of money on it. All the details except the case I found in various old boards, which are not naturally needed.
To assemble an amplifier on the TDA2030, you can use various methods and solutions, in this case I will use a hinged installation. Since many pins are connected to ground, I recommend making a branching wire.

Next, proceed to soldering the joints.
The count of the conclusions of the chip is from left to right, with the marking and conclusions aimed at you.

After you have assembled the circuit - check it. We’ll connect the speaker and check the amplifier at a low volume.

If everything works, proceed to the next step.
I had a finished building. It is better to bring the radiator out to better cool its surface. Otherwise, overheating may occur in the housing.
Attach the radiator, connectors, remove the power wires, set the on - power switch.

The amplifier has the following characteristics:
  • Supply voltage - from ± 4.5 to ± 25 V.
  • Output power - 18 watts.
  • The nominal frequency range is 20-80.000 Hz.

Almost all such microcircuits are very hot and therefore will not work for a long time without a radiator.

Final view:

This is a truly incredible simplicity scheme, which even beginner hams can afford. With all this, it has decent characteristics for its minimum size.
Assemble your amplifier and you will be happy friends.

Pin
Send
Share
Send

Watch the video: 35W AUDIO AMPLIFIER WITH SINGLE TDA2030A IC (November 2024).